The Rhino is the lastest bender in our product line.
The new Rhino is designed for the bigger jobs. It has a wider throat than any other bender in it's class. This allow you to bend materials 3 1/2 " wide. It Bends the same metals as our Pro2 just bigger. 7/8" rod, 3 1/2 X 5/16 flat stock and 2" round and square tubing. The Rhino is also designed for you to use a cheater. It's heavy duty construction makes it strong enough to abuse.
The Rhino comes with the following:
- Mount Plates
- Mounting hardware
- Three pins
- Stop block
- Round sleeve
- Five stackable sleeved dies
- Instructional DVD and CD
All of our benders are made of hot rolled American steel and are guaranteed for life. To fully use your bender's capability, please see our section on dies.
Rhino Bending Specifications:
- Bends round or square solid rod up to 7/8"
- Flat bar stock up to 3 1/2" wide by 5/16" thick
- Edge bend flat bar stock (hard way) 3/8" by 1 1/4" wide
- Bend square tubing up to 2" OD at 16 to 18 ga
- Round tubing up to 2" OD
- Angle iron up to 1" at 11 ga
Note: Some of the bends above will require a die.
Mounting Suggestions for the Rhino:
