Bulldog Bender

p>The all new Bulldog metal bender has been engineered to handle most production needs at a reasonable price. The Bulldog bender picks up where our Mighty Mite Bender leaves off, and is more agile and cost effective than the Pro2. The Bulldog bender comes with the following:

  • Mounting Stand * requires welding
  • Mounting hardware
  • Three pins
  • Stop block
  • Round sleeve
  • Five stackable sleeved dies
  • Instructional DVD and CD

All of our metal benders are made of hot rolled American steel and are guaranteed for life. To fully use your bender's capability, please see our section on dies.

Pro2 Bending Specifications:
  • Bends round or square solid rod up to 5/8"
  • Flat bar stock up to 2" wide by 1/4" thick
  • Edge bend flat bar stock (hard way) 1/4" by 7/8" wide
  • Bend square tubing up to 1" OD at 16 to 18 ga
  • Round tubing up to 1" OD
  • Angle iron up to 1" at 11 ga
Note: Some of the bends above will require a die.

Mounting Suggestions for the Bulldog:

There are no products to list in this category.
 
Copyright © 2017 Howron Industries, LLC. Metal Benders 
Shop with Confidence