Product Image	Item Name-	Price
	Edge Bend and Angle Iron Die Set These dies come in a set of three dies that allow you to bend 1/8" x 3/4" flat stock the "hard way" or angle iron with flange in or out up to 1/2". One die is 2" in diameter, one is 1 1/2" in diameter and one is 1" in diameter, giving you the...	$39.95 Add:
	Edge Bend Die - 2 in 1 This is one of our most popular specialty dies. It allows you to bend flat stock the "hard way" - i.e, on the edge. This product works on either 1/8" or 1/4" flat stock up to 1 1/4" wide. It bends approximately 45 degrees per full pull with an 8...	$38.00 Add:
	Hinge and Scroll Tool The hinge/scroll tool allows you to bend flat stock all the way around the 3/8" center pin, essentially creating a 3/8" closed loop on the end of the material. It is used for hinges and also for scrolling. This tool may be used with the Mighty Mite...	$29.95 Add:
	Mount Plate - Top and Bottom (Set of 2) Two-piece set of precut, predrilled mount plates (top & bottom), which help you mount your Pro 2 Bender to a secure bench or the floor. Risers are not included.	$39.95 Add:
	Round Sleeve - 1 inch 1" round sleeve with 3/8" hole for the Mighty Mite. PLEASE NOTE: This sleeve is already included with the purchase of a Mighty Mite Bender.	$5.00 Add:
	Square Stop Block - 1 1/2 Inch 1 1/2" square by 2 3/8" square stop block with offset hole for the Pro 2 Bender. PLEASE NOTE: This stop block is already included with the purchase of a Pro 2 Bender.	$12.00 Add:
	Square Stop Block - 1 Inch 1" square stop block with 3/8" offset hole. PLEASE NOTE: This stop block is already included with the purchase of a Mighty Mite Bender or the Pro 2 Conversion Kit.	$5.00 Add: